Sanyo C3632A - Preparing the Indoor Side Tubing

26 S4359249
Hou to replace the grille
(1) Close the flaps.
(2) Reinstall the grille into the lower part while aligning
its tabs on the upper part. (Fig. 3-54) Insert the
tabs in the slots and push the lower part of the
grille back into position.
(3) Press at each of the 5 tabs to completely close
the grille. Make sure that the grille and frame are
firmly fitted together. (Fig. 3-55)
3-18. Preparing the Indoor Side Tubing
Tubing can be extended in 4 directions (4 directions for
KS2432A) as shown in Fig. 3-56.
Arrangement for Left Tubing (except KS2432A)
(a) Cut out the left tubing outlet. (Fig. 3-57)
Arrangement for Right Tubing
(a) Cut out the right tubing outlet using a hacksaw.
(Fig. 3-58)
Arrangement for Left-rear and Right-rear Tubing.
(a) It is not necessary to cut a hole.
2244_T_I
2245_T_I
Left-rear
tubing
Left
tubing
Right-rear
tubing
(Recommended)
Right tubing
0949_T_I
0951_T_I
Right tubing
outlet
0950_T_I
Left tubing
outlet
Fig. 3-57
Fig. 3-58
Fig. 3-56
KS2432, KS2432A
Tubing can be extended in 4 directions as shown in
Fig. 3-52.
Arrangement for Right-rear Tubing
(a) Remove the 2 screws and slide out the side
cover. (Fig. 3-59)
(b) Extend the wide tube from the outdoor side and
connect it directly to the mating tube inside the
indoor unit. Use a flare nut. (Fig. 3-60)
KS3032, KS3632
1356_T_I
Fig. 3-59
Fig. 3-54
Fig. 3-55