EasyManua.ls Logo

Sanyo CDP-150 - Page 11

Sanyo CDP-150
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Notes on the Rechargeable
Nickel-Cadmium Battery
Always keep the charging terminal clean.
Only use the NBP-30B rechargeable nickel-
cadmium battery (not supplied) with the
CDP-150. If a different type of rechargeable
battery is installed,
itcannot be recharged
by the CDP-1 50.
Under normal usage conditions, this battery
can be recharged approximately 500 times.
If the operating time decreases drastically
even when the rechargeable nickel-cad-
mium battery is properly recharged,
purchase a new NBP-30B rechargeable
nickel-cadmium battery.
Do not use any AC adaptor other than the
one supplied with the CDP-1 50.
Do not charge continuously for 24 hours or
more. Doing so can cause the performance
of the rechargeable nickel-cadmium battery
to deteriorate.
Do not short-circuit the “+” and “-” terminals
of the rechargeable nickel-cadmium bat-
tery.
Do not put rechargeable nickel-cadmium
batteries in water or fire.
Do not disassemble rechargeable nickel-
cadmium batteries.
Battery F3echarging or Replacement
If the rechargeable nickel-cadmium battery or
alkaline- batteries are weak and discharged,
“Q” flashes in the display, then the power
automatically turns off. If this occurs, recharge
the rechargeable nickel-cadmium battery or
replace the alkaline batteries before using the
unit.
This unit can be used if the rechargeable
nickel-cadmium battery or alkaline batteries
are removed, as long as the supplied AC
adaptor is connected.
When you are not going to use the unit for
one month or more, take the rechargeable
nickel-cadmium battery or alkaline batteries
out of the battery compartment.
To remove the rechargeable nickel-cadmium
battery or old batteries, press the negative side
of the battery so the battery pops out from the
compartment.
-1o-

Related product manuals