I
POWER SUPPLY
I
I
OPERATION WITH RECHARGEABLE NICKEL-CADMIUM BATTERY
I
(not supplied with CDP-150)
RECHARGEABLE NICKEL-CADMIUM BAT-
TERY INSTALLATION
NOTE:
Only the NBP-30B rechargeable nickel-cad-
mium battery should be used with the CDP-150.
If a different type of rechargeable battery is
installed, it cannot be recharged by the
CDP-
150.
To purchase the NBP-30B rechargeable nickel-
cadmium battery, contact one of the Sanyo
Service regional offices.
●
1.
Fully charge the rechargeable nickel-cad-
mium battery before using it for the first
time.
Slide the battery compartment on the bot-
tom of the unit to the right, then swing the
battery compartment open.
2. Insert the NBP-30B rechargeable nickel-
cadmium battery (not supplied) into the
battery compartment. Be sure to observe
the proper polarity (the “+” and “-” signs, as
indicated inside the battery compartment).
3. Close the battery compartment.
\
-8-
To Next Page
Loading...
