Sanyo CDP-150 - Alkaline Battery Installation

.
ALKALINE BAITERY INSTALLATION
(not supplied)
Insert two “AA’ batteries (not supplied) into the
battery compartment on the bottom of the unit.
,.
CAUTION:
V44-tEN INSTALLING THE BAl_fERIES
TO prevent leakage from the batteries, whit
its corrosive and can cause personal !njul
amd damage to the unit, observe the follov
ir~g precautions:
1-
2.
31-.
&
5
6.
z
$L
The batteries must be installed correctl!
Match the polarities (+ and–signs) on th
batteries, to the polarities shown on th
back of the unit.
Do not mix new batteries with old or use
batteries.
Only use batteries of the same type ant
brand.
If the unit will not be used for an extendef
period of time, remove the batteries am
store them in a cool place.
Carefully follow the battery manufacturer’:
instructions for proper use and disposal
DO NOT ALLOW YOUNG CHILDREh
TO HANDLE BATTERIES. ..
When inserting the batteries, mistakenl}
inserting even one with improper polarity
will cause leakage.
Never charge, heat, disassemble, orthrow
batteries into a fire.
NOTE:
When the batteries have become discharged,
ttk?y must be disposed of in a safe manner
Mich complies with all applicable la WS.
NOTE: If the operating buttons do not func
tiom when pressed...
1.
2.
Remove the batteries and/or disconnect th(
AC adaptor from the unit. Wait a few sec
amds, then reinstall the batteries or reconnec
tlhe AC adaptor.
Mthe buttons still do not function, insert new
batteries or charge the rechargeable nickel
cadmium batt- ~
-11-