EasyManua.ls Logo

Sanyo CE14A2-C - Page 36

Sanyo CE14A2-C
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service manual CHASSIS 2112-Series EC7-A
21
5.1.2 Meaning of each adjustment.
Adjustment Meaning Range Initial value Suggested value
GEOMET
V.SLOPE Ramp generator amplitude 0 to 63 40
V.SHIFT Vertical centre 0 to 63 32
V.AMPL Vertical amplitude 0 to 63 43
H.SHIFT Horizontal phase 0 to 63 37
H.AMPL Width 0 to 63 32
S-CORR Vertical S-correction 0 to 63 09
CENTR TXT OSD and TXT Centre 0 to 63 25
VIF
PLL PLL of video IF 0 to 03 02
PLL L’ PLL of video IF in L’ system 0 to 03 02
AGC Automatic gain control 0 to 63 16
WHITE
G White point, green gain 0 to 63 28
B White point, blue gain 0 to 63 26
G2
BRI G2 adjust brightness level 0 to 63 50
ADJ Service Line Adjust - -
AKB Enable AKB servo ON/OFF ON ON
K-DRV RGB drive 0 to 7 02 02
MORE
SEMI MUTE Attenuation (dB) by pressing Mute
once
0 to 63 12
INI NVM Non volatile memory initialisation - - -
CONFIG
FFI PLL constant time of IF ON/OFF OFF OFF
TXTSET East countries selection ON/OFF OFF OFF in continental models
ON in export models
OSO HV discharge mode ON/OFF OFF OFF
OEM TV set trademark ON/OFF OFF OFF in models SANYO
ON in models OEM
TUN-UK Tuner selection for UK (only band
UHF)
ON/OFF OFF for no UK models.
ON for UK models.
Lp Enable of system L’. ON/OFF OFF in models without L’.
ON in models with L’.
RADIO Enable of radio. ON/OFF OFF in models without radio.
ON in models with radio.
STANDARD
PAL B/G PAL B/G configuration ON/OFF ON ON
PAL D/K PAL D/K configuration ON/OFF OFF OFF in models without D/K
ON in models with D/K
PAL I PAL I configuration ON/OFF OFF OFF in models without system I
ON in models with system I
SECAM B/G SECAM B/G configuration ON/OFF OFF OFF in PAL models
ON in SECAM models
SECAM D/K SECAM D/K configuration ON/OFF OFF OFF
FRANCE SECAM L configuration ON/OFF OFF OFF in PAL models
ON in SECAM L models
NTSC 443 NTSC 4.43MHz configuration ON/OFF ON ON
NTSC M NTSC 3,58MHz configuration ON/OFF OFF OFF
V-STAT
Video processor status - -
I2C BUS
I
2
C Bus stop - -
Note: The adjustment of width, H.AMPL, lacks effect whenever the circuit of adjustment is not mounted, which is
optional, according to it has been indicated previously.

Related product manuals