For UK:
For AU:
1.
2.
3.
Set the VIDEO/PHOfUO select switch (rear of the unit) to PHONO or
1. Select WIDE(3” function. “VIDEO’ aPPears on the display.
VIDEO according to the source to be played.
2. Follow the instructions supplied with the video equipment.
Select “VIDEO/PHr3JrY function. “VD-PH” appears on the display.
Follow the instructions supplied with the turntable or video equipment.
CAUTION:
If the VIDEO/PHONO select switch is set incorrectly, an excessively large
output distorted sound from the video equipment or excessively low output
sound from the turntable will result.
~ ... ..E3JEFO~AND~
~
Recording copyright material without permission of the copyright
owners is usually an infringement. If you wish to re-record
copyright material permission from the copyright owner is
necessary. SANYO doea not approve of, and cannot be held
responsible for, any unlawful use of this machine.
Use deck B for recording.
1. Press the cassette holder (EJECT portion) to open it and load the
cassette for recording.
2. Set the DOLBY NR button to ON or OFF as desired.
Dolby NR ON ............ “DOB NR” appears
Dolby NR OFF ...........” an B NW disappears
Automatic record muting
Undesirable parts of a programme can be omitted while recording.
Press the REC MUTE button on the remote control once while recording.
“REC” blinks on the display and a 5-second unrecorded blank space is
created, then the cassette deck enters the record pause mode. “REC”
remains lit and” ➤ ” blinks on the display.
- To add another 5-second blank space, press the REC MUTE bunon
again.
- To resume recording, press the ➤ bunon.
Note:
The record muting function does not operate during CD computer recording
or tape computer dubbing.
Accidental erasure prevention tabs (for protecting
valuable recordings)
Accidental erasure can be prevented by breaking out the tabs on the end
of the cassene tape (where the tape is not exposed) using a screwdriver
or similar implement.
If a tab is broken out in error and you wish to re-record the tape, simply
block the tab hole using adhesive tape and the tape can be used for
recording again.
Side A
For Cr02 tape
>+ TV
%1 ,
Side B
Break out tab A for side A.
Break out tab B for side B.
13
To Next Page
Loading...
