Need help?Do you have a question about the Sanyo DC-F430AV and is the answer not in the manual?
Speaker System| reception frequency FM | 87.5-108 MHz |
|---|---|
| reception frequency AM | 522-1710 kHz (9 kHz step) |
| reception frequency AM (alternative) | 520-1710 kHz (10 kHz step) |
| maximum power-handling capacity (front speaker) | 80 W (peak) |
| nominal impedance (front speaker) | 6 ohms |
| dimensions (front speaker) | 210(W) x 330(H) x 240(D) mm |
| weight (front speaker) | 3.6 kg (per speaker) |
| maximum power-handling capacity (centre speaker) | 80 W (peak) |
| nominal impedance (centre speaker) | 8 ohms |
| dimensions (centre speaker) | 270(W) x 130(H) x 184(D) mm |
| weight (centre speaker) | 1.4 kg |
| maximum power-handling capacity (surround speaker) | 40 W (peak) |
| nominal impedance (surround speaker) | 16 ohms |
| dimensions (surround speaker) | 210(W) x 130(H) x 162(D) mm |
| weight (surround speaker) | 0.9 kg (per speaker) |
CD Player Section| sampling frequency | 44.1 kHz |
|---|---|
| laser output | 0.6 mW (Continuous wave max.) |
| wave length | 790 nm |
Cassette Deck Section| frequency response (CrOz tape) | 50 Hz to 15 kHz |
|---|---|
| frequency response (Normal tape) | 50 Hz to 14 kHz |
| signal-to-noise ratio | 60 dB (Dolby NR ON) |
| fast forward/rewind time | Approx. 110 sec. (C-60) |
Amplifier Section| output power main amplifier | 40 W x 2 (at 6 ohms, 10% distortion) |
|---|---|
| output power centre amplifier | 40 W (at 8 ohms, 10% distortion) |
| output power surround amplifier | 20 W x 2 (at 16 ohms, 10% distortion) |
| power requirements | AC 230-240 V, 50 HZ |
| power consumption | 130W |
| dimensions | 270(W) x 330(H) x 333(D) mm |
| weight | 9.8 kg |
Avoid exposure to invisible laser radiation when unit is open or interlocks are defeated.
Do not adjust or repair except by qualified personnel to avoid hazardous radiation.
Methods for tuning radio stations and storing preset channels.
Steps for recording CDs to cassette using computer or manual edit modes.
Guide to setting and using the on/off and sleep timers for automated operation.
Detailed explanation of remote control buttons for various system functions.
To Next Page
