Sanyo DC-PT70 - Service Mode Setup Procedures; Displaying Service Mode Screens; Setting Market Code

- 3 -
SERVICE MODE
C. Setup Procedures
1. Displaying SERVICE MODE screen
Display Service Mode screen following the instructions "How to
enter Service Mode" above.
Region 0 Market
BackendVersion
S
31130
A0
Loader Version 17 Z09 Y03
Value
2. Displaying Internal Setup screen
Push button within three seconds after operating the
Service Mode display.
On the Internal Setup screen shown on the right, set up Market
and Region.
3. Setting Market code
3.1. While a highlighted indicator is displayed on the right side
of the Market denotation, push numeric buttons on the
remote controller.
When you push wrong number , push CLEAR button.
(The indicator reset to "00")
Be sure to input by double figures.
Maket code of UK model is "02", and XE model is "03".
3.2. Specify the code of the model in accordance with the
Market/Region Setup Table above.
3.3 Once the desired code is displayed, push p button to
move the highlighted indicator to the Region input area.
Internal Setup
Market WM
Region 2
Exit
00-WM 01-SFC 02-UK 03-XE 04-S18
05-
SS 06-PA 07-AU 08-CN 09-JP
10-FXE 11-MX 12-NT
09
Internal Setup
Market WM
Region 1
Exit
00-WM 01-SFC 02-UK 03-XE 04-S18
05-
SS 06-PA 07-AU 08-CN 09-JP
10-FXE 11-MX 12-NT
00
(Reference figure)
(Reference figure)
(Reference figure)