Sanyo DP32640 - CLOCK TIMER; LIGHT SENSOR

– 7 –
MECHANICAL DISASSEMBLY (Continued)
ANALOG BOARD AND
MAIN (DIGITAL) BOARD REMOVAL
Remove 8 screws (B:3x10) to take the analog board and the
main (digital) board off.
RC LED BOARD REMOVAL
Remove the RC LED board.
SPEAKER
TERMINAL BASE SIDE
H
E
E
G
G
TERMINAL BASE REAR
BUTTON UNIT
B
B
B
B
MAIN (DIGITAL)
BOARD
RC LED BOARD
SPEAKER
WALL WIRE
B
ANALOG
BOARD
B
B
B
SPEAKER REMOVAL
Take off each speaker from back cabinet.
ELECTROSTATICALLY SENSITIVE DEVICES
Many solid-state devices (especially Integrated Circuits) are Electrostatically Sensitive,
and, therefore, require special handling techniques as described under “Servicing
Electrostatically Sensitive Devices,” on page two in this service literature.
ATTENTION – The earth sheet should be returned to its
previous position after servicing.
ATTENTION – Confirm that mounting wall wire is
installed when install the back cabinet.
BUTTON UNIT REMOVAL
Remove the button unit.
TERMINAL BASE SIDE REMOVAL
TERMINAL BASE REAR REMOVAL
Remove 2 screws (E:3x6) and 2 special screws (G) an 1
special nut (H) to take the TERMINAL BASE SIDE and the
TERMINAL BASE REAR off.