Sanyo DP32746 - CONNECTING DIGITAL AUDIO OUT JACK TO A MULTI-CHANNEL RECEIVER

14
Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
DIGITAL AV CONNECTIONS
 Position your DTV at least 2 feet from stereo
speakers. The magnets in the speakers may affect the
picture quality.
Dolby
®
Digital Audio provides 5.1 channels of
surround sound (five full-range channels [5] and
one low-frequency effect channel [.1]). A fiber
optics cable is used to carry the 5.1 surround
sound (for low-noise signal transfer).
BACK
VIEW OF
DTV
OPTICAL
DIGITAL CABLE
1
Using a Fiber Optics cable, connect the
DTV’s Digital Audio Output to the Digital
Audio Input of a Multi-Channel Receiver.
(Fiber optics cable is not supplied.)
2
Press POWER to turn on the DTV, then turn
on external equipment.
NOTES:When making the connection, do not pinch or
kink the fiber optics cable.
Red light visible at the Digital Audio Output
does not necessarily indicate that Dolby
®
Digital 5.1 audio is available. Digital audio is
made up of light pulses that the human eye
cannot detect. Dolby
®
Digital 5.1 audio is
available at the Digital Audio Output only
when received as part of a Digital signal.
What you will need for connections:
Optical Cable – 1
MULTI-CHANNEL
RECEIVER
1
REMOTE CONTROL
2
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must
run All Channel Search twice before you can
select the AV inputs.
CONNECTING DIGITAL AUDIO OUT JACK TO A MULTI-CHANNEL
RECEIVER