15
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
ANALOG AV CONNECTIONS
Switch off DTV and external equipment before
connecting cables.
(Cables are not supplied.)
BACK VIEW OF VCR
DTV AV
INPUT
JACKS
1
Connect VCR’s Audio Video Out to the
DTV’s VIDEO1 jacks.
NOTE: For Mono VCR (Single Audio Jack),
connect VCR Audio Out to DTV Audio (L)
Input.
22
Optional
Connect VCR’s S-Video Out to the HDTV's
S-Video In Jack.
NOTE: S-Video jack connections override
VIDEO1 Video jack connection.
3
Press POWER to turn on the DTV, then turn
on external equipment.
4
Press INPUT to select
Video 1
to view the VCR
program.
What you will need for connections:
Audio Video Cable – 1
S-Video Cable – 1
S-VIDEO
JACK
1
REMOTE CONTROL
4
3
22
Press the INPUT key after connecting cables to access
the VIDEO1 input. There is NO need to tune to a blank
channel.
“No Signal” will appear randomly on the screen when
no signal is detected at the VIDEO1 video jack.
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must
run All Channel Search twice before you can
select the AV inputs.
NOTES: Don’t be fooled by the
phrase “Available in
High-Definition.” Com-
posite jacks offer only
480i (SDTV) resolution.
To view available High-
Definition (HD) pro-
grams, you must con-
nect your HD equipment
to the Component or
HDMI jacks.
Video 1
USING THE ANALOG VIDEO JACKS TO CONNECT A VCR
(OR OTHER ANALOG DEVICE)
To Next Page
Loading...
