Sanyo DSR-3706PA - Page 15

About Configuration via Menus
14
English
■ To configure pre-alarm recording:
Press the MENU button to open the MAIN MENU
screen, and choose “2. RECORD SET”.
On the RECORD SET screen, choose “7. ALARM
REC MODE SET”.
Set “ALARM RECORDING” to “ENABLED”.
Set “PRE-ALARM RECORDING” to “ON”.
A WARNING screen appears. Choose “YES”, and
then turn the S-dial clockwise.
Configure the recording rate and duration.
When you are done, press the EXIT/OSD button.
7
6
5
4
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: **** FPS, DURATION: ****
=> (01731 ALARMS CAN BE RECORDED)
ALARM TRIGGER : ALARM
MOTION SENSOR ->
3
2
1
■ To change the items indicated on the
operation display (status bar):
Press the MENU button to open the MAIN MENU
screen, and choose “3. GENERAL SET”.
On the GENERAL SET screen, choose
“1. DISPLAY SET”.
Specify whether to show or hide each item by
choosing either ON or OFF.
When you are done, press the EXIT/OSD button.
■ To configure the passwords:
Press the MENU button to open the MAIN MENU
screen, and choose “3. GENERAL SET”.
On the GENERAL SET screen, choose
“3. SECURITY LOCK SET”.
Configure each of the two passwords.
(Each password can consist of 4 to 8
alphanumeric characters.)
qAllows you to configure the administrator password.
wAllows you to configure the user password.
eAllows you to specify the access level required to perform
recording tasks (ADMIN/USER).
When you are done, press the EXIT/OSD button.
4
<SECURITY LOCK SET>
LEVEL PASSWORD(4-8) USE
ADMIN -------- OFF
USER -------- OFF
REC CONTROL : ADMIN
q
w
e
3
2
1
4
<DISPLAY SET>
DATE : ON
TIME : ON
QUALITY : ON
AUDIO : ON
ALARM COUNT : ON
ALARM TYPE : ON
TITLE : ON
VIDEO LOSS : ON
3
2
1