To Next PageTo Next PageWhat to do if my Sanyo DWM-390 DVD Player remote control does not work properly?
If the remote control for your Sanyo DVD Player isn't working right, it could be due to a few things: * Weak or incorrectly installed batteries. Check the battery polarity (+ or -) and replace the batteries if needed. * The remote control not aimed correctly. Make sure you're aiming the remote control at the remote sensor window on the DVD player.
What to do if the disc tray on my Sanyo DWM-390 does not open?
If the disc tray on your Sanyo DVD Player won't open, it might be locked. Press the q button on the unit until “Un-LOC” appears.
What to do if my Sanyo DVD Player has no power?
If your Sanyo DVD Player isn't powering on, the power plug might not be properly connected to the AC wall outlet. Make sure the power plug is fully inserted into the outlet.
Why is there no sound coming from my Sanyo DVD Player?
If you're not getting any sound from your Sanyo DVD Player, there could be a few reasons: * The TV might be turned off. Ensure that your TV is turned on. * The audio cables might not be properly connected. Check that the audio cables are securely plugged into the jacks. * The audio equipment connected to the DVD player may be off. Turn on any audio equipment connected with the audio cable.
Why does my Sanyo DWM-390 say 'No Play' on the TV screen?
If your Sanyo DVD Player shows 'No Play' on the screen, it could be due to a few reasons: * An unplayable disc is loaded. Ensure the loaded disc is playable, checking its logo, type, color system and regional code. * “PARENTAL” is set. Cancel the parental lock function or change the rating level. Reset it after play. * The disc may not have the correct file or data. Load a playable disc.
Why is there no picture on my Sanyo DWM-390?
If you're not getting a picture from your Sanyo DVD Player, here are some possible causes: * An unplayable disc is loaded. Make sure you are using a playable disc. * The TV is not set to receive signal from the player. Ensure that the TV is set to the correct input function. * The video cable is not connected. Verify that the video cable is securely connected to the jack. * The S-video cable is not connected. Ensure the S-video cable is connected to the jack. * “PROGRESSIVE” mode is set. Select “INTERLACE” mode.
What to do if my Sanyo DVD Player does not start playback?
If your Sanyo DVD Player isn't starting playback, consider these possibilities: * No disc is loaded. Load a disc into the player. * An unplayable disc is loaded. Ensure you're using a playable disc. * The disc is loaded incorrectly. Make sure the disc is loaded on the disc tray correctly, with the label side up. * The disc is dirty. Clean the disc or replace it. * “PARENTAL” is set. Cancel the parental lock function or change the rating level. Reset it after play.
How to fix a dark FL display on my Sanyo DWM-390?
If the FL display on your Sanyo DVD Player is dark, it might be set to “Dark”. Reset it to “Normal”.
What to do if the operation or display of my Sanyo DVD Player is not normal?
If the operation or display of your Sanyo DVD Player isn't normal, the unit might need to be reset. Disconnect the power cord, reconnect it, and then resume operation.
General| Progressive Scan | Yes |
|---|---|
| Remote Control | Yes |
| Type | DVD Player |
| Region Code | 1 |
| Power Supply | AC 120V, 60Hz |
| Playable Media Format | DVD, CD |
| Video Output | Composite Video, S-Video, Component Video |
| Disc Compatibility | DVD-Video |
