- 4 -
SERVICE MODE
D. IMPORTANT NOTE
1. Once the "Market/Region" settings are written into EEPROM (IC810) on the DVD substrate, they cannot be reset.
(However, updating the system using CD-R enables you to make new settings.)
2. While the Internal Setup screen is displayed, pushing the Power button enables you to terminate the operations without
making any settings.
HOW TO LOAD SOFTWARE FOR MPEG P.W.BOARD
1. Power on, then open tray.
2. It take on CD-ROM for UPDATE software to the tray, and tray close.
3. TV screen display “Reading” and FL display “UPDATING”
4. For the time being, tray open and FL display "GOOD-BYE".
(caution) The update is not completed though the tray opens.
5. When software loading finished, "GOOD-BY" on a FL display disappears.
6. Next, set up market code and region code by "SERVICE MODE"
CD-ROM part code is "0PRADC9687--A".
CAUTIONS FOR PWB OR IC ASSY EXCHANGE
After an MAIN board(614 332 3860) or IC ASSY(410 531 3201) exchange should carry out loading of the software by the newest
CD-R, and should check operation.
How to attach gear rack
Slide gear is slid, and the position
of a hole is united.
The tooth of gear is
united as shown in a
figure.
How to take out the disc.
Main unit
Pushing cylindrical thing
To Next Page
Loading...
