-12-
J.REMOVING DOOR
Remove 3 hex nuts securing the upper hinge,
remove 3 hex nuts securing the lower hinge and
remove 1 special screw securing the door arm
(rocated at the bottom of the door sash).
NOTES
- After replacing the door, check for microwave ene-
rgy leakage with a leakage detector. Microwave
energy leakage must be below the limit of
5 mW/cm
2
.
K.RELEASING TYPE CONNECTOR
This oven is provided with locked type connectors.
When you remve a connector, pull the connector
while releasing the lock by pressing “A” point shown
below.
Do not pull the wire of the connector.
Figure 16
Figure 15
Figure 14
Figure 13
A
A
A
S105 Connetor
S 1,102, 103, 106 Connetor
Pull connector case
(Never pull the wire)
To Next Page
Loading...
