EasyManua.ls Logo

Sanyo EM-F3400SW - User Manual

Sanyo EM-F3400SW
36 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
WW
WW
W
ARNING TO SERARNING TO SER
ARNING TO SERARNING TO SER
ARNING TO SER
VICE TECHNICIANSVICE TECHNICIANS
VICE TECHNICIANSVICE TECHNICIANS
VICE TECHNICIANS
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING
SERVICING TO AVOID POSSIBLE EXPOSURE TO
EXCESSIVE MICROWAVE ENERGY
(a) Do not operate or allow the oven to be operated with the door open.
(b) Make the following safety checks on all ovens to be serviced before activating the magnetron or other
microwave source, and make repairs as necessary :
(1) Interlock operation, (2) proper door closing, (3) seal and sealing surfaces (arcing, wear, and other damage),
(4) damage to or loosening of hinges and latches, (5) evidence of dropping or abuse.
(c) Before turning on microwave power for any service test or inspection within the microwave generating
compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity,
and connections.
(d) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation and
transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before
the oven is released to the owner.
(e) A microwave leakage check to verify compliance with the Federal performance standard should be performed
on each oven prior to release to the owner.
REFERENCE NO. SS-860312
File No :File No :
File No :File No :
File No :
SUPPLEMENT OF SUPPLEMENT OF
SUPPLEMENT OF SUPPLEMENT OF
SUPPLEMENT OF
MicrMicr
MicrMicr
Micr
owave Ovenowave Oven
owave Ovenowave Oven
owave Oven
EM-V3405SW (U.S.A.)EM-V3405SW (U.S.A.)
EM-V3405SW (U.S.A.)EM-V3405SW (U.S.A.)
EM-V3405SW (U.S.A.)
SER SER
SER SER
SER
VICE MANUALVICE MANUAL
VICE MANUALVICE MANUAL
VICE MANUAL
Pr Pr
Pr Pr
Pr
oduct Code No.oduct Code No.
oduct Code No.oduct Code No.
oduct Code No.
437 550 00437 550 00
437 550 00437 550 00
437 550 00
See the Service Manual of EM-F3400SW (SM-860304)
except the items described in this Service Manual.

Table of Contents

Other manuals for Sanyo EM-F3400SW

Preview: Service Manual
Service Manual23 pages

Questions and Answers

  • H
    Holly AndersonAug 14, 2025
    What to do if my Sanyo Microwave Oven does not heat up?
    • J
      James BernardAug 14, 2025
      If your Sanyo Microwave Oven isn't heating, try the following: * Touch the “START” key and measure the voltage between the white and black wire leads for the primary winding of the H.V. transformer. * Check the H.V. Capacitor or H.V. Diode with an Ohm-Meter after removing the lead wires. * Consider replacing the H.V. Diode, H.V. Transformer, or the Control Circuit Board.
  • N
    Nicholas HarrisAug 18, 2025
    Why won't my Sanyo Microwave Oven start cooking?
    • A
      Alejandra MooneyAug 18, 2025
      If your Sanyo Microwave Oven isn't starting, you can try these steps: * Check the continuity of Connector S102 between Pins (O and BL) with the door closed after removing connector S102 from the Control Circuit Board. * Adjust or replace the Door Sensing Switch.
  • S
    spowellAug 21, 2025
    What to do if my Sanyo EM-F3400SW has low microwave power output?
    • S
      Scott NguyenAug 21, 2025
      If your Sanyo Microwave Oven has low power output, consider these solutions: * Replace the Thermal Protector for the Magnetron or the Thermal Protector for the Cavity. * Temporarily short across the terminals of the Blower Motor. * Replace the Control Circuit Board.
  • K
    Kimberly AlvaradoAug 25, 2025
    How to troubleshoot mis-display in the display window of Sanyo Microwave Oven?
    • D
      Donna WilsonAug 26, 2025
      To troubleshoot a mis-display or no display on your Sanyo Microwave Oven, check the following: * Check the continuity of the Fuse. If necessary, check the Thermal Protector for the Magnetron, the Thermal Protector for the Cavity, and the AC Power Cord. * Check the resistance of the Control Circuit Board. * Check the power supply voltage on the Control Circuit Board.
  • A
    Anne RamosAug 27, 2025
    What to do if there is no buzzing by touching keys on my Sanyo EM-F3400SW Microwave Oven?
    • M
      Martha JensenAug 28, 2025
      If there is no buzzing sound when you touch the keys on your Sanyo Microwave Oven, check the normal operation of the Control Circuit Board.
  • J
    Joseph HernandezAug 31, 2025
    What to do if cooking operation will not start in Sanyo EM-F3400SW Microwave Oven?
    • M
      Megan BrownAug 31, 2025
      If your Sanyo Microwave Oven cooking operation will not start, you can try to: * Check the power supply to the oven. * Check the primary interlock switch. * Check the thermal protector for the magnetron. * Check the continuity of the door sensing switch. * Adjust or replace the door sensing switch.
  • F
    ffreemanSep 3, 2025
    How to fix low microwave power output in Sanyo Microwave Oven?
    • J
      Jennifer FaulknerSep 3, 2025
      If the microwave power output is low in your Sanyo Microwave Oven, consider the following: * Replace the thermal protector for the magnetron. * Check the operation of the blower motor when the 'START' key is touched. * Replace the control circuit board.
  • T
    Tara LongSep 7, 2025
    What to do if Sanyo EM-F3400SW display is not working?
    • D
      Daniel AyalaSep 7, 2025
      If there is no display or a mis-display in the display window of your Sanyo Microwave Oven when touching the keys, you may: * Replace the control circuit board. * Check the resistance of the touch key board. * Check the power supply voltage on the control circuit board.
  • K
    katiegrossSep 12, 2025
    How to fix magnetron operating on high when lower cook power is selected on Sanyo EM-F3400SW?
    • S
      Stephanie GaySep 12, 2025
      To resolve the issue of the magnetron operating at a high level when a lower cook power is selected on your Sanyo Microwave Oven, replace the control circuit board.

Sanyo EM-F3400SW Specifications

General IconGeneral
TurntableYes
Cooking Levels10
ColorWhite
Voltage120V
Power Output1000 watts
Control TypeElectronic
Weight37.5 lbs
TypeCountertop Microwave Oven

Related product manuals