Turning Your Phone On and Off
Turning YourPhone On
©
Press .
Once yourphone is on, it may display “Looking for
service.” When your phone finds a signal, it automatically
enters standby mode. At this point, you are ready to
begin making and receiving calls.
If yourphone is unable to find a signal after 15 minutes of
searching, a Power Save feature is automatically
activated. When a signal is found, your phone
automatically returns to standby mode.
In Power Save mode, your phone searches fora signal
periodically without yourintervention. You can also
initiate a search for Sprint service by pressing any key
(when yourphone is turned on).
Turning YourPhone Off
©
Press and hold for two seconds until you see the
powering down animation on the display screen.
Your screen remains blank while your phone is off
(unless the battery is charging).
Using Your Phone’s Battery and
Charger
Sprint-approved or manufacturer-approved batteries
and accessories can be found at Sprint Stores or
through the manufacturer; or call 1-866-343-1114 to
order. They’re also available at www.sprint.com.
WARNING
Use only Sprint-approved or manufacturer-
approved batteries and chargers with your
phone. The failure to use a Sprint-approved
or manufacturer-approved battery and
chargermay increase the risk that your
phone will overheat, catch fire, or explode,
resulting in serious bodily injury, death, or
property damage.
Tip
The Power Save feature conserves your battery
power when you are in an area where there is no
signal.
14 Section 2A. Phone Basics
To Next Page
Loading...
