Adjusting the Alert Volume
You can set the alert volume separately from the ringer
volume setting.
1. Press > Settings > Sounds > Volume >
Advanced....
2. Select Alarms, Text Message, Picture Mail, Voicemail, or
VoiceSMS.
3. Using the navigation key, select Separate Vol.
4. Press the navigation key right or left to choose a
volume level and press Done (left softkey).
Alert Notification
Set yourphone to alert you with an audible tone when
you change service areas, a call has been connected,
there are messages, oryour network signal is fading as
well as once a minute during a voice call.
1. Press > Settings > Sounds > Alerts.
2. Select Beep Each Minute, Out of Service, Connect,
Signal Fade/Call Drop, or Messaging.
n
If you select Messaging, select Text Message,
Picture Mail, Voicemail, or VoiceSMS.
3. Use your navigation key to select a setting and
press .
Silence All
The Silence All option allows you to mute all sounds
without turning yourphone off.
To activate Silence All:
©
With the phone open, press the volume key down
repeatedly in standby mode. (The screen will display
“Silence All.”)
To deactivate Silence All:
©
With the phone open, press the volume key up
repeatedly to select a volume level.
Tip
You can make the ringer vibrate at any volume level
by checking
Always Vibrate.
Section 2B. Settings 35
Settings
To Next Page
Loading...
