Sanyo KHS1232 - Page 19

16
2) Switch Positions for Up to 4 Units
Table 2 shows the positions you can use for up to 4
indoor units installed in the same room.
Table 2
An indoor unit cannot be remote controlled if its remote
control unit is too far away (more than 25 ft.). If the
remote control unit does not seem to work correctly,
bring it closer to the unit being operated and try again.
For this reason, if the remote control unit is to be used
from a fixed position, operation should be checked at
that position before mounting.
NOTE
Indoor Unit
Unit No.
Remote control unit Indoor unit
1212
1
OFF OFF OFF OFF
2
ON OFF ON OFF
3
ON ON ON ON
4
OFF ON OFF ON
ON
1 2
PCB
Address switch
(for receiving)
Addresses 1 and 2 are
both in the OFF position
at time of shipment.
Fig. 8
095-313SanyoTD00.12.1311:12AMページ16