15
8-2. Remote Control Unit Installation
Position
The remote control unit can be operated from either a
non-fixed position or a wall-mounted fixed position.
To ensure that the air conditioner operates correctly, do
not install the remote control unit in the following places:
●
in direct sunlight
●
behind a curtain or other place where it is covered
●
more than 25 ft. away from the air conditioner
●
in the path of the air conditioner’s airstream
●
where it may become extremely hot or cold
●
where it may be subject to electrical or magnetic inter-
ference
1) If Non-fixed Position
Raise the rear plate of the remote control unit mounting
cradle and insert the remote control unit. The unit can be
used either in that position (placed on a table, for
instance) or held in the hand. (Fig. 5)
2) If Wall-mounted Fixed Position
Install the remote control unit at a convenient location on a
nearby wall. However, before attaching the remote control
unit mounting cradle, check that the remote control unit
can operate from the desired wall position. (Fig. 6)
8-3. Address Switches
If you are installing more than 1 indoor unit (up to 4) in the
same room, it is necessary for you to assign each unit its
own address so each one is operated by its own remote
control unit. You assign the addresses by matching the
switch positions of each indoor unit with the switch posi-
tions of its remote control unit. The switches of the remote
control unit are shown in Fig. 7.
For instance, to set up 2 indoor units, switch Unit A’s
address switches and the switches of its remote control
unit to OFF – OFF. Then switch Unit B’s address switches
and the switches of its remote control unit to ON – OFF. It
is important that you match the switches of the air condi-
tioner unit with the switches of its remote control unit.
1) Finding the Address Switches
Remove the battery compartment lid and unit’s 2 batter-
ies. You can see then the switches inside the battery com-
partment. (Fig. 7)
Remote Control Unit
Binding-head
tapping screw
(3 16 mm (5/8"))
×
Fig. 6
Rear
plate
Remote control unit
Remote control unit
mounting cradle
Fig. 5
12
ON OFF ON OFF
Address
ON OFF OFFON
Address switch
(for transmitting)
Addresses 1 and 2 are
both in the OFF position
at time of shipment.
12
Fig. 7
095-313SanyoTD00.12.1311:12AMページ15
To Next Page
Loading...
