EasyManua.ls Logo

Sanyo LCD-24K40 - Operation Range; Remote Control Batteries Installation

Sanyo LCD-24K40
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Remove the battery compartment cover.
Insert two size AA batteries (1.5V) according to
"+" and "-" polarity markings inside the battery
compartment.
Close the battery compartment cover.
1
2
3
30
30
15
15
5m
Point Remote Control toward LCD TV (Infrared
Remote Receiver) whenever pressing the
buttons. Maximum operating range for Remote
Control is about 16.4’ (5m) in front, about 30° to
the left or the right, about 15° for up or down.
To insure safe operation, please observe the following precautions:
Use (2) AA, alkaline batteries.
Replace two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contacting with water or liquid.
Do not expose the Remote Control to moisture, or heat.
Do not drop the Remote Control.
If a battery has leaked on the Remote Control, carefully wipe case clean
and install new batteries.
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Do not expose batteries (battery pack or batteries installed) to excessive heat
such as sunshine, fire or the like.
Infrared Remote Receiver
REMOTE CONTROL BATTERIES INSTALLATION
OPERATION RANGE
BEFORE OPERATION
LCD-19K40(R-S-W)ENG.indd 14LCD-19K40(R-S-W)ENG.indd 14 4/13/2010 1:35:55 PM4/13/2010 1:35:55 PM

Other manuals for Sanyo LCD-24K40

Related product manuals