Sanyo LCD-32E3 - Adjustment Instructions; Source Calibration

7
4. Adjustment instruction
At any input source then press the remote controller buttons “<”, “EXIT” and “>” to enter factory mode.
During Factory menu, if “MENU” or “EXIT” key is pushed, system will exit factory mode.
4-1. Source Calibration
4-1.1. Set the TV input source to YPbPr; ASTRO-859 signal setting to PG2 program number 924.
(PG2 mode Timing 924 and Pattern 924 100% Color Bar.)
4-1.2. Entering into factory Mode: Press up or down key of remote control to select “Auto Calibration”, Press
䇸OK䇹 key to ˴.
-> Source calibration performed automatically when finished that will show OK.