Why doesn't the chamber temperature match the set value in my Sanyo MCO-19AIC(UV) Accessories?
The chamber temperature might not match the set value if the ambient temperature differs by less than 5°C from the set value or if the outer door is closed while the inner door is left open. Ensure that the ambient temperature is appropriately different and both doors are properly closed.
Why is a large quantity of CO gas being consumed by my Sanyo Accessories?
A large quantity of CO gas might be consumed if the doors are frequently opened and closed, if there are gas leaks from connectors due to deterioration of the CO gas supply pipe or pinhole leaks, if the packing seal for the inner door is defective, or if the access hole is open. Check these areas to resolve the issue.
What to do if the CO gas concentration 2 does not match the set value in Sanyo MCO-19AIC(UV)?
The CO gas concentration may not match the set value if the secondary pressure for the CO gas pressure regulator is not at the specified value of 0.03 MPaG (0.3 kgf/cm2G) or if the CO gas supply pipe is blocked. Please, check if the secondary pressure for the CO gas pressure regulator is at the specified value and make sure that the CO gas supply pipe is not blocked.
How to troubleshoot if Sanyo MCO-19AIC(UV) Accessories incubator does not operate at all?
If the incubator does not operate, first check if it is properly plugged in. If it is, determine if there is a power outage or a tripped circuit breaker interrupting the power supply.
What to do if the chamber temperature does not rise in Sanyo MCO-19AIC(UV)?
The chamber temperature may not rise if there is not enough water in the humidifying pan. Check the water level and refill if necessary.
What to do if the key is not working in Sanyo MCO-19AIC(UV)?
Make sure the key lock function is turned OFF.
Specifies the environmental conditions required for optimal and safe operation of the Incubator.
Stresses the importance of a strong, level floor to prevent tipping and ensure stability.
Provides guidelines on humidity levels and the avoidance of flammable or corrosive gases.
Outlines the initial steps of removing packing materials and cleaning the unit.
Details the procedure for grounding the Incubator to prevent electric shock.
Warns against climbing on or placing objects on the Incubator to prevent damage or injury.
Lists required accessories and initial preparations for H2O2 decontamination.
Provides a detailed procedure for performing H2O2 decontamination of the Incubator.
Outlines essential handling, storage, and disposal precautions for the H2O2 reagent.
General| Brand | Sanyo |
|---|---|
| Model | MCO-19AIC(UV) |
| Category | Accessories |
| Language | English |
To Next Page
