Sanyo MCO-19M - Page 75

74
SPECIFICATIONS
Name Multi-gas Incubator
Models MCO-19M MCO-19M(UV) MCO-19M(UVH)
External dimensions W620 x D710 x H900 mm (W24.4 x D28.0 x H35.4 inch)
Internal dimensions W490 x D523 x H665 mm (W19.3 x D20.6 x H26.2 inch)
Interior volume 162 L (5.72 cu.ft.)
Exterior Painted steel
Interior Stainless steel containing copper
Outer door Painted steel
Inner door Stainless steel with gasket
Gastight split door 4 doors made of tempered glass
Trays 3 trays made of stainless steel containing copper
W450 x D450 x H12 mm (W17.7 x D17.7 x H0.47 inch), Maximum load: 7 kg/tray
Access port Inner diameter: 30 mm (1.18 inch), On the back side
Insulation Rigid polyurethane foamed-in place
Heating system DHA system (heater jacket + air jacket system)
Heater 314 W
Humidifying system Natural evaporation with humidifying pan
Temperature controller PID control system
Temperature display Digital display
CO
2
controller PID control system
CO
2
density display Digital display
O
2
controller PID control system
O
2
density display Digital display
Air circulation Fan assisted
Air filter 0.3 µm, Efficiency: 99.97% or higher
UV lamp
----- 4W X 1 (ozone-free emission)
Water level sensor
Optical
Alarms
Automatic set temperature alarm, Automatic set CO2 density alarm
Automatic set O2 density alarm, Upper limit temperature alarm
various gas/sensor/heater alarms
Remote alarm contacts Allowable contact capacity: 30 VDC, 2 A
CO
2
inlet connection 4 to 6 mm (0.157 to 0.236 inch) diameter tube can be connected
CO
2
inlet pressure 0.03 MPaG (0.3 kgf/cm
2
G, 4.3 psiG)
O
2
inlet connection 4 to 6 mm diameter tube can be connected
O
2
inlet pressure 0.05 MPaG (0.5 kgf/cm
2
G, 7.1 psiG)
Weight 94 kg
Get other manuals https://www.bkmanuals.com