Sanyo MCO-19M - Control Panel and Keypad

12
Control panel and keypad
1. Upper limit regulator:
This regulator is used to set the upper
temperature limit.
2. OVERHEAT indicator:
This indicator lights when the chamber
temperature reaches the upper limit.
3. MENU Key:
Press this key to access the menu.
4. Contrast knob:
Turn this knob to adjust the contrast of the
LCD.
5. BUZZER Key:
Press this key to silence the buzzer.
Note:
It is not possible to silence the
buzzer for an upper limit temperature
alarm.
6. CE Key:
Press this key to clear the entered value
when entering a setting.
7. Cursor Keys (Up, Down, Left, and Right):
Use these keys to move the cursor on the
LCD panel.
8. ENTER Key:
Press this key to select a menu command.
When entering a setting, pressing this key to
move to the next parameter.
9. Numeric Keys
10. H
2
O
2
Key:
Press this key to start H
2
O
2
decontamination.
Refer to page 49 for details.
※ The following optional components must be installed to perform decontamination.
・UV Lamp Add-on Kit (MCO-19UVS) (This is provided as standard equipment for the MCO-19M(UV).)
・H
2
O
2
Decontamination Kit (MCO-HL)
・H
2
O
2
Generator (MCO-HP)
LCD panel
1
3
4
5
6
7
8
9
10
2
Get other manuals https://www.bkmanuals.com