(2)
iIIILid"
appears on the
dsplay
and
procesl
doe.
not
start.
1) Check the 2 shafts mounted
to
the
nd.
Push the shafts to make sure that
they
slide
In
and
out
smoothly.
Shafts
If the shafts
do
not slide smoothly,
2) Check the position of the both lock
shah.
Lock
shafts
(1) Check the springs lItted to the shalls.
(2) Apply
grease
to the shaft sliding perl
When the
cover
is
opened,
(1) Check
if
the shalls are
in
due position
On
just
about vertical position).
(2)
Check
if
the lock shafts open when pushlld outward and
they
retum to the original position by spring force when
relaased.
If they can not move normally,
(1) Remove
any
foreign matter which
is
pinched and
jams
the
.hall
(2) Replace the spring, etc. If
In
trouble.
(3) Apply
grease
to the shaft sliding perl
-
36-
To Next Page
Loading...
