Sanyo MLS-3781L - Movable Handle and Lid Lock Not Working (E7); Abnormally High Pressure (E8)

Movable handle and lid lock is not
BeIw'I!Ien White 1 and Black 3
r
Checking position
Detecllon switch
Conductivity checking
poanlons
• Detection switch 1
Between Black 1
and 2
• Detection switch 2
Between WhKe 1
and Black 3
• Wire Nos. are
Indicated
on the
connect0r5
;
for engagement of the lid. If not caught,
(1)
Remove any foreign matter, which maybe sticking.
(2) If the lock shall retum spring is weakened, replace it
(3) If the lock shaft does not move smoothly, apply grease.
Check
the condudivity of the switch when is closed. If
no conductivity,
(1) Adjust the switch mounting poaition.
(2) If no conductivity is found ever when the lever is pushed,
replace the housing set M.
If no conductivity,
(1) Adjust
the switch mounting position.
(2)
If no conductivity Is found ever when the lever Is pushed,
replace the housing set OS.
- 42-