NVM-4070 Portable Navigation System 14 Chapter 2 Getting Started
Contents Index
2.2 Mounting the NVM-4070 in your vehicle
The NVM-4070 comes with a car Mounting kit and a car adaptor to help install
your device in your vehicle. The car Mounting kit uses a suction cup on the
windshield/dashboard to offer flexible mounting options for the NVM-4070.
This section shows how to install the car mount kit in your vehicle’s wind-
shield/dashboard using the suction cup. Below is the backside view of the
NVM-4070.
Figure 4: NVM-4070 Slot for Windshield & Dashboard Car Mounting kit
WARNING: Do not use the car mount kit under low temperatures. The cradle
may come off because of insufficient suction power.
WARNING: Make sure that the car mount kit does not obstruct the driver’s
view, or interfere with the operation of vehicle airbags and safety devices.
NOTICE TO DRIVERS IN CALIFORNIA AND MINNESOTA: State
law prohibits drives in California and Minnesota from using suction mounts
on their windshields while operating motor vehicles. SANYO does not take
any responsibility for any fines, penalties, or damages that may be incurred as
a result of disregarding this notice.
NOTE: Do attach the Car Adaptor to your device when you use it in vehicle.
Rechargeable batteries may sometimes not be chargeable in the vehicle.
Slots for Windshield & Dashboard Car Mounting kit
To Next Page
Loading...