NVM-4070 Portable Navigation System 19 Chapter 3 System
Contents Index
Chapter 3 System
3.1 NVM-4070 Operating Basics
You can now turn it on to calibrate the screen. After screen calibration, proceed
to system settings configuration.
3.2 To turn on and calibrate the device:
1. Turn on the Battery ON / OFF switch.
2. Tap the center of the target as it moves around the screen.
NOTE: If you turn on/off the device by using Battery switch, the clock will be
reset. At that time, please set Date & Time again.
NOTE: When you first turn on your device, you will be asked to calibrate the
screen. This process ensures the accuracy of the touchscreen when used.
NOTE: Calibration is repeated until it succeeds.
To Next Page
Loading...