Sanyo PDG-DWT50L - Page 74

PDG-DWT50L
- 74-
To replace the lamp, refer to the following guide.
1.
Loosen the screw on the lamp
cover (A), and remove the
lamp cover as shown (B).
2.
Loosen the two captive
screws (A) on the lamp
module. Lift the module
handle up (B) in the direction
shown.
3.
Pull firmly on the module
handle in the direction shown
to remove the lamp.
4.
Reverse steps 1 to 3 to install
the new lamp module and
replace the lamp cover.