Sanyo PDG-DWT50L - Page 76

PDG-DWT50L
- 76-
8-2-4 Replace the color wheel
Installing the Optional Color Wheel
The PDG-DWT50L projector comes with a four-segment color wheel installed. An additional
six-segment color wheel is optional. To replace the color wheel (located under the lamp cover adjacent
to lamp 1) refer to the following guide.
Note:
Wait until the lamp house and the color wheel cool off.
1.
Loosen the captive screw (A)
on the lamp cover.
2.
Remove the lamp cover by
sliding it in the direction of the
arrow (B).
3.
Unscrew the retaining screws (x
4) on the four-segment color
wheel.