Sanyo PLC-XW200K - Remote Control Battery Installation; Remote Control Operating Range; Remote Control Code

12
Part Names and Functions
Toensuresafeoperation,pleaseobservethefollowingprecautions:
 ● Usetwo(2)AAAorLR03typealkalinebatteries.
 ● Alwaysreplacebatteriesinsets.
 ● Donotuseanewbatterywithausedbattery.
 ● Avoidcontactwithwaterorliquid.
 ● Donotexposetheremotecontroltomoistureorheat.
 ● Donotdroptheremotecontrol.
 ● Ifthebatteryhasleakedontheremotecontrol,carefullywipethecasecleanandinstallnewbatteries.
 ● Riskofanexplosionifbatteryisreplacedbyanincorrecttype.
 ● Disposeofusedbatteriesaccordingtotheinstructionsoryourlocaldisposalruleorguidelines.
Openthebattery
compartmentlid.
Installnewbatteries
intothecompartment.
Replacethe
compartmentlid.
Two AAA size batteries
Forcorrectpolarity
(+and–),besure
batteryterminalsare
incontactwithpinsin
compartment.
1 2 3
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5 m)
and60degreesinfrontoftheprojector.
Remote Control Operating Range
Remote Control Battery Installation
16.4'
(5m)
30°
Remotecontrol
30°
The2 differentremote controlcodes (Code 1–Code2) are
assignedtothisprojector.Switchingtheremote
control codes prevents interference from other remote
controlswhenseveralprojectorsorvideoequipment
nexttoeachother are operatedatthesametime.Change
theremotecontrolcodefortheprojectorfirstbefore
changingthatforthe remote control.See"Remotecontrol"
intheSettingMenuonpage52.
PressandholdtheMENUandIMAGEbuttonsformore
thanfivesecondstoswitchbetweentheCode 1andCode
2.TheinitialcodeissettoCode 1.
Remote Control Code
MENU button
IMAGE button