What to do if Sanyo Projector cannot be turned on until cooling is completed?
Your Sanyo Projector cannot be turned on because the projection lamp is being cooled down. Please wait until the cooling process is completed before attempting to turn it on again.
How to troubleshoot Sanyo PLC-XE32 Projector when it's off?
If your Sanyo Projector is off, the AC power cord might be unplugged. Make sure to check the AC power cord to ensure it is properly connected.
What does it mean when the LAMP REPLACE indicator lights yellow on Sanyo Projector?
When the LAMP REPLACE indicator lights yellow on your Sanyo Projector, it means the projection lamp is nearing the end of its life. Replace the projection lamp with a new one promptly and reset the lamp replacement counter after the replacement.
What to do if Sanyo PLC-XE32 detected an abnormal temperature rise?
If your Sanyo Projector detected an abnormal temperature rise inside, inspect the air filters and remove any obstructions near the intake and exhaust fan openings. Wait for the POWER indicator to stop flashing before attempting to turn the projector on again.
What to check if Sanyo Projector cannot be turned on?
If your Sanyo Projector cannot be turned on, it may be detecting an abnormal condition. Check the power supply circuit and the fan control circuit.
What to do if Sanyo PLC-XE32 detected an abnormality in the cooling fan or power supply?
If your Sanyo Projector detected an abnormality in the cooling fan operation or in the power supply secondary circuits, check the fan operation, power supply lines, and the driving signal status.
What to check if primary power supply circuit does not operate properly in Sanyo PLC-XE32?
If the primary power supply circuit in your Sanyo Projector is not operating properly, check the power primary circuit and parts such as the AC cord, F601 (Fuse), Power board, and SW902 (Thermal sw.) for shorts.
Key warnings regarding fire, shock, and proper usage.
Importance of unblocked ventilation for cooling.
Guidelines for projector placement to prevent hazards.
Step-by-step guide to power on.
Procedures for powering down the unit.
Choosing computer input (Computer 1 or 2).
Automatic or manual tuning for computer signals.
Automatic adjustment of sync, dots, horizontal/vertical.
Precise manual adjustment of image parameters.
Choosing Video input.
Selecting specific video inputs.
Auto detection or manual setting of video standards.
Fine-tuning video image parameters.
Configures automatic power off and on functions.
Enables projector operation security via PIN code.
Procedures for entering and changing the PIN code.
Understanding projector status lights.
Cleaning and replacing air filters.
Steps to replace the projection lamp.
Resetting the lamp usage counter.
Solutions for common projector issues.
Detailed specs of the projector.
General| Vertical scan range | 50 - 100 Hz |
|---|---|
| Horizontal scan range | 15 - 100 kHz |
| Projection technology | LCD |
| Contrast ratio (typical) | 400:1 |
| Projector native resolution | XGA (1024x768) |
| Keystone correction, vertical | ±20 ° |
| Lamp type | UHP |
| Lamp power | 200 W |
| Light source type | Lamp |
| Focus | Manual |
| Focal length range | 22.5 - 27 mm |
| I/O ports | D-Sub15 S-Video Composite Monitor out D-sub15 Audio out Service Port Mini DIN 8-pin |
| Dimensions (WxDxH) | 330 x 237 x 80 mm |
| F-number (relative aperture) | 1.65 |
| Power consumption (typical) | 205 W |
Weight and Dimensions| Weight | 2900 g |
|---|
To Next Page
