Sanyo PLC-XE32

Part Names and Functions
12
To ensure safe operation, please observe the following precautions:
 ● Usetwo(2)AAorLR6typealkalinebatteries.
 ● Alwaysreplacebatteriesinsets.
 ● Donotuseanewbatterywithausedbattery.
 ● Avoidcontactwithwaterorliquid.
 ● Donotexposetheremotecontroltomoistureorheat.
 ● Donotdroptheremotecontrol.
 ● Ifthebatteryhasleakedontheremotecontrol,carefullywipethecasecleanandinstall
new batteries.
 ● Riskofexplosionifabatteryisreplacedbyanincorrecttype.
 ● Disposeofusedbatteriesaccordingtotheinstructions.
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the
compartment lid.
Two AA size batteries
For correct polarity
(+ and –), be sure
battery terminals are in
contact with pins in the
compartment.
Remote Control Battery Installation
1 2 3
Point the remote control toward the
projector (Infrared Remote Receiver)
when pressing any button. Maximum
operating range for the remote control is
about 16.4' (5 m) and 60° in front of the
projector.
Operating Range
16.4'
(5 m)