What to do if the LAMP REPLACE indicator lights yellow on my Sanyo Projector?
If the LAMP REPLACE indicator lights up yellow, you should promptly replace the projection lamp with a new one. After replacing the lamp, remember to reset the lamp replacement counter.
What to do if my Sanyo PLC-XE40 Projector detects an abnormal condition and won't turn on?
Check the power supply circuit and fan control circuit.
Why my Sanyo PLC-XE40 cannot be turned on until cooling is completed?
The projector is either preparing for stand-by mode or the projection lamp is currently cooling down.
General| Brightness | 4000 ANSI Lumens |
|---|---|
| Resolution | 1024 x 768 (XGA) |
| Contrast Ratio | 2000:1 |
| Lamp Life | 2000 hours (Normal Mode), 3000 hours (Eco Mode) |
| Display Technology | LCD |
| Aspect Ratio | 4:3 |
| Projection Size | 30 to 300 inches |
| Lamp Type | UHP |
| Input Ports | S-Video, Composite Video |
| Output Ports | Audio |
| Noise Level | 35 dB (standard) |
Important warnings and guidelines for safe projector operation and placement.
Identifies and explains the functions of each button on the remote control.
Steps for safely connecting the projector to the AC power outlet.
Details on connecting the projector to a computer using various cables.
Instructions for connecting video sources like VCRs or DVD players.
Steps for connecting equipment using component video cables.
Step-by-step guide to power on the projector, including PIN code entry.
Instructions for properly shutting down the projector to maintain lamp life.
Explains how to navigate and use the projector's on-screen menu system.
How to select between Computer 1 and Computer 2 input sources.
Automatic and manual selection of computer system signals for optimal display.
Function to automatically adjust image parameters for computer input.
Detailed manual adjustment of various image parameters for specific computer signals.
Procedures for selecting Video or S-Video input sources.
How to select Component or RGB (Scart) video input sources.
Setting the video system (PAL, NTSC, etc.) or component video signal format.
Selecting preset image levels for video sources like Dynamic, Cinema, or Blackboard.
Fine-tuning of image parameters for video sources including Color and Tint.
Customizing the projected image size for video input signals.
Customizing startup logo, capturing images, and setting logo PIN code.
Settings for ceiling/rear projection, terminal function, and power saving.
Steps for replacing the projection lamp and resetting the lamp replacement counter.
Solutions for common problems like no power, no image, or no sound.
To Next Page
