Sanyo PLC-XE32

Basic Operation
20
How to Operate the On-Screen Menu
The projector can be adjusted or set via the On-Screen
Menu. Refer to the following pages regarding each
adjustment and setting procedures.
Press the Point ◄► buttons to select a Menu icon
to adjust and press the Point ▲▼ buttons to select
an item to adjust.
Press the SELECT button to show the item data.
To adjust the data, press the Point ◄► buttons.
Refer to the following pages for each adjustment.
To close the On-Screen Menu, press the MENU
button again.
Press the MENU button to display the On-Screen
Menu.
 Note:
The selected item is not active until the SELECT
button is pressed.
1
2
3
SELECT button
POINT buttons
Remote Control
MENU button
Menu bar
Pointer
(red framed )
Menu icon
Item data
Press the Point◄►
buttons to adjust the
value.
SELECT
button
Pointer (red framed )
Press the Point ▲▼ buttons to
move the pointer.
Item
On-Screen Menu
Quit
Exit this menu.