− 2 −
1. DISASSEMBLY
and unlock the lens adapter
rear board
and 3 pin cable
board then pull out 5 pin wire harness
7. Remove the six screws and the power
board then pull out 4 pin wire harness
6. Remove the two screws and the iris
power board
iris board
timing board
FPC
sensor board
9. Remove FPC and the four screws
and remove the sensor board kit
10. Remove the two set screws
3. Remove the four screws
and pull out the rear cover
8. Remove the four screws
5. Remove the six screws and the timing
board and pull all wire harness(4 pcs)
and remove the rear board
and pull out the bottom cover
2. Remove the four screws
and FPC on sensor board
and pull out the front cover
4. Remove the four screws
and pull out the top cover
1. Remove the four screws
Anti-dusty Film
11. Remove the two screws and pull out the Tripod
12. Remove the lens cap
To Next Page
Loading...
