4
3
LINK lamp
When connected to the network, the camera
LINK lamp flashes. After you turn on the power,
it takes approximately one minute for the
“NETWORK” setting menu to appear on the
“OPTION” screen.
4 LAN terminal (RJ45 terminal)
Used to connect the camera to your network.
5AC24V/DC12V terminal
Inputs the power.
Connect this terminal to the power supply.
• When the camera is turned on, the POWER
lamp lights and the version information of the
camera is displayed on the startup screen for
about 10 seconds.
b For zoom/focus
While viewing the live image, you can perform
focusing or zooming operation.
1 c: Tele d: Wide j: Near l: Far
2 Pressing the button once starts auto-focus
function.
b For menu operations
1 j: Moves the cursor upward.
l: Moves the cursor downward.
c: Changes the setting value or moves the
cursor to the right.
d: Changes the setting value or moves the
cursor to the left.
2 Pressing and holding the button for about
3 seconds displays the main menu.
While performing menu operations, the
button may be used to switch the menu
screen to the next one.
CAMERA VER
X.XX-XX
SET
1
2
Side panel
L5CC2_XE(INSTALLATION).book 4 ページ ２００８年１月２３日 水曜日 午後４時８分
To Next Page
Loading...
