Sanyo VM-EX26P - Installing the Battery Pack; Erasure-Prevention Switch

RECORDING BASIC STEPS
Installing the battery pack
The supplied battery pack has not been charged,
make sure to charge it before using it on the
camcorder for the first time.
Ce a,
a aaa le aa aa aa ee ed a eae ee RE EOE
[1 Set the POWER switch to “OFF”.
2 Align the right side of the battery pack with the line
on the camcorder. Then, while pressing it down,
slide the battery pack toward the right until a click is
heard.
lS TOT NM aa a
Tel erepe els!
iia
raa a Eer ea ara Anana aa
f
5
st ADE PIE ao ee VAAN PLA i EE
To remove the battery pack, push and hold down the
BATT button, then slide the battery pack in the opposite
direction of the arrow on the battery pack (©).
Erasure-prevention switch
To prevent accidental erasure of recorded material, use
the erasure-prevention switch, as described below.
(A) Recording is possible
(B) Recording is not possible
==
Before loading the cassette
Recorded cassettes or new cassettes tapes may be
loosely wound. Loose tape winding can be eliminated by
gently turning with a finger the left reel, see illustration, at
the bottom of the cassette.
Eo
NARNIE D
Ae
PEPPER EA
Press the EJECT button, the cassette holder will
open.
4
Te aM
A
2 Insert the cassette fully with the window facing
outwards.
I aa SS NS Narn as WMS at MAAR NE MTD aie Nl at aa aah
$
3 Gently press on the indication “PUSH” on the
k z . .
a cassette holder until it clicks into place.
a a a ad ne eee PERI RERELAL ACRE
E Unloading the cassette
1 Press the EJECT button, the cassette holder will open.
2 Remove the cassette.
3 Gently press on the indication “PUSH” on the cassette
holder until it clicks into place.
t Notes:
@ Do not cover the holes at the bottom of the cassette.
@ Store the cassettes in their case, away from strong
light or heat sources, standing upright (vertical) to
prevent dust from entering, as well as uneven tape
winding.