Sanyo VPC-TH1 - Page 15

– 15 –
1. Three screws 1.7 x 3
2. Connector
3. TB1 board
4. Three screws 1.7 x 2.5
5. Two screws 1.7 x 3
6. Screw 1.7 x 4
7. Screw 1.7 x 3
8. Two screws 1.7 x 3
9. Heat sink CMOS
10. Holder TB1
11. Spacer CA
12. Screw 1.7 x 2.5
13. Holder CA
14. FPC
15. Connector
16. Two screws 1.7 x 4
17. Two screws 1.7 x 4
18. Holder lens chassis
19. Holder lens
20. Remove the lens part.
21. Holder lens
22. Spacer lens bottom
23. Three screws 1.4 x 3.5
24. Lens
25. Screw 1.7 x 2
26. Heat sink tape CMOS
27. Holder heat CMOS TB1
28. Assy, flexible pwb CA1 + mounting lens
29. Two screws 1.7 x 7
30. Screw 1.7 x 3
31. Connector
32. ST1 board
33. Spacer ST1
34. Remove the solder.
35. Assy, lamp
36. Cover triger
37. Remove the solder.
38. Spacer con ST1
39. Flexible pwb CP1 & TB3
40. Four screws 1.7 x 3
41. CP1 board
42. Flexible pwb CP1 & TB3
43. Heat sink rub ASIC
44. Screw 1.4 x 2
45. Earth jack
46. Two screws 1.7 x 3
47. Chassis bottom
26. Heat sink tape CMOS
35. Assy lamp dressing method
35. Assy lamp soldering order
39, 42. Flexible pwb CP1 & TB3
48. Three screws 1.7 x 2.5
49. TB3 board
50. Chassis right