Sanyo XT-24S7000F - Page 19

TP.V56.PB759
QR-ZZPJ-017A
版权 CVTE 所有，本文档内容属商业机密。未经允许，任何组织或个人不得以任何形式复制和传播。
13
10. MOUNT PRECAUTIONS
（组装注意事项）
Note1: The height of H should be more than or equal to 8mm, otherwise you must add the
mylar under PCB bottom.
H 的高度必须大于等于 8mm,如果小于 8mm,则必须在 PCB 底层加麦拉片绝缘.
Note2: The diameter of D should be less than8mm. Use M3 screw to mount the power supply
unit on the screw fixing column. The maximum torque force is 0.4N-M.
D 的直径须小于 8mm，将电源锁在螺丝柱上需使用 M3 的螺丝。最大扭力为 0.4N-M。
Note3: The Power supply unit is designed without the case. Pay attention to ESD protection at
any time.
因为本产品为无外壳之设计, 故在任何时候均应注意静电防护。
Note4: Speaker line must be twisted.
喇叭线必须使用双绞方式。
Note5: Speaker line cannot be parallel to the AC line, if they are parallel to each other, the
distance should not be less than 8cm.
喇叭线和整机 AC 线不可以平行走线，如果平行走线，距离不可小于 8cm。