Sanyo XT-24S7000F - Specifications

TP.V56.PB759
QR-ZZPJ-017A
版权 CVTE 所有，本文档内容属商业机密。未经允许，任何组织或个人不得以任何形式复制和传播。
12
9. CONFIGURATION & GENERAL PRECAUTIONS
（使用注
意事项）
 Relative humidity: ≤ 80%.
 相对湿度： ≤ 80%。
 Storage temperature: -10~60°C.
 存储温度： -10~60°C。
 Operation temperature: 0~40°C.
 使用温度：0~40°C。
 Protect the board from static electricity in case of damage to the IC.
 请使板卡远离静电。
 Keep the board away from conductor when it is working.
 请确保板卡工作时远离导体。
 Don’t push or pull the connectors when the board is working.
 板卡工作时请勿按压和扭曲。
 Don’t press, distort or disassemble the board.
 请勿拆解板卡。
 Clean the board with soft dry cloth when it’s dirty.
 如果板卡脏了，请用干布擦拭。
 Don’t power on before panel is correctly connected.
 正确接好驱屏线前请勿接通电源。
 The whole machine certification performance will be subject to the impact of the whole
machine, must use the whole machine to test and confirm.
 整机认证性能会受整机匹配的影响，必须使用整机进行测试确认。
 When using the I2C interface to communicate with the outside, please confirm the
matching of the pull up resistance and the series resistance with CVTE hardware engineer.
 使用 I2C 接口跟外部通信时，需与我司硬件工程师确认上拉电阻以及串接电阻的匹配性
 To ensure communicating properly between the mainboard and external expansion
modules, it's recommend that test related control and communication signals and power
supply voltage waveform after installing prototype to confirm whether to meet the
relevant requirements.
 为保障 TV 主板与外部扩展模块间能正常通讯控制，建议装样机后对相关控制和通讯信号以及供电等的
电压波形进行测试，确认是否满足相关要求。