Revision 02/24/2022 document 630-1057
Model 6120/6123
Electronic Safe Lock Installation Instructions
General Information
Your 6120/6123 Lock was shipped with the keypad, keypad base,
and cable disconnected. If your lock is not already assembled,
temporarily connect them as shown in these instructions.
You should install fresh batteries in the keypad (S&G recommends
Duracell® alkaline batteries) and check the function of the lock prior to
installation by pressing 123456# and observing the lock bolt retract,
then extend 6 seconds later. After this check, disconnect the
cables from the keypad by pulling on the connectors (NOT on the
cables themselves).
Item
Quantity
Description
1
1
Lock body
2
1
Keypad
3
1
Keypad Base
4
1
Keypad cable
5
1
Bolt Position Cable (BPI) / Door Switch
6
4 Keypad mounting screws (2 standard/2 metric)
7
6
Lock Mounting screws (3 standard/3 metric)
8
3
Lock serial number
To Next Page
Need help?
General
