Need help?Do you have a question about the Sargent Degree DG-2 and is the answer not in the manual?
Details the utility patented keyway and protection against bumping for fixed cylinders.
Builds on DG1 with patented side bar locking and geographic exclusivity.
Combines DG1/DG2 features with UL437 certification for high security.
Illustrates DG1 key cuts from bow to tip with dimensional specifications.
Lists part numbers and lengths for bottom pins used in DG1 cylinders.
Lists part numbers and lengths for driver pins for DG1 standard cylinders.
Provides part numbers and lengths for master wafers for all DG-series.
Lists part numbers and lengths for control drivers for DG-6300 LFIC cores.
Lists part numbers and lengths for bump resistant driver pins specific to DG1.
Illustrates DG2/DG3 key cuts with dimensional specifications.
Lists part numbers and lengths for bottom pins used in DG2/DG3 cylinders.
Provides part numbers and lengths for master wafers for all DG-series.
Lists part numbers and lengths for control drivers for DG-6300 LFIC cores.
Lists part numbers and lengths for driver pins for DG2/DG3 cylinders.
Details HPC key cutting machines, card numbers, DSD#, cutters, and jaws.
Lists ITL key cutting machines, vice inserts, and cutter numbers.
Provides information on Framon key cutting machines and associated kits.
Explains pinning formulas for 6-chamber fixed core cylinders (Non-LFIC).
Details pinning formulas for 6300 LFIC control chambers (3 & 4).
Describes construction master keying using a lost/wafer design for DG1, DG2, and DG3 cylinders.
Details SARGENT's stamping options for key and cylinder identification.
Explains the use of tamper-proof packaging for master keys and key blanks.
Details the contents of the 437 DG1 standard pinning kit for DG1 cylinders.
Describes the 437 DGM master kit for pinning DG1, DG2, and DG3 cylinders.
Provides recommendations for lubricating and cleaning Degree cylinders.
To Next Page
General
