saro EB 26 - Safety Notices for Ice Cube Maker

21
Stand 12/2012 WBS / 10/2018 TM
SAFETY NOTICES
• Before the rst start-up, read these operating instructions carefully and observe the information
given therein.
• Incorrect operation and improper handling can lead to malfunctions on the device and injury to the
user.
• Observe the accident prevention regulations applicable to the area of application and the general
safety regulations.
• Ensure a safe stand on a dry, non-slip surface that is adequate to the weight of the equipment. If the
ground is not stable enough, the unit may tip over and cause injury.
• Do not place the device on a hot surface and keep away from any heat source and direct sunlight.
• The ice cube maker may only be transported upright.
• Do not tilt the unit by more than 45 degrees.
• Do not move the device during use.
• Before moving the unit, unplug the power cord.
• Make sure that the device does not tip when moving. This could lead to injuries
• Keep packaging materials (plastic lm) out of the reach of children.
• The unit may only be connected to a properly installed power outlet.
• Do not plug any other device into the same outlet. Make sure that the wall socket is plugged in.
• is generally accessible so that the device can be disconnected from the power supply in an
emergency.
• Do not use ice cubes produced in the rst 2 hours.
• After longer transport, the unit should not be put back into operation until after 24 hours.
• Do not let the power cord hang over sharp edges and keep it away from hot spots, objects and open
ames.
• When unplugging the power cord, always pull the plug housing and never the cable. Turn o the
device before starting.
• Make sure that unintentional pulling on the cable or tripping over it is not possible.
• Do not damage or modify the power cord, pull, strain, bend or squeeze it, twist or roll it up.
• Do not clean the unit with an open water jet.
• The unit must not be immersed in water or other liquids or wetted with liquids.
• Do not place heavy objects or objects lled with liquids on the unit. Things could fall down and cause
injury. Liquids could be spilled, in the inside of the device and transmit electricity.
• Only use the original parts provided for this purpose when operating the unit.
• Never touch the device, cable or plug with wet hands.