The system can be confi gured to switch automatically to the reference platform for
initialization (the measured value line shows Ref). Following initialization, you can
switch to the counting platform.
Setting: Applic./Applic.1/Count./REF.WP menu item 3.13.
h
If automatic reference sample updating is enabled, the update is performed on the
active platform; in other words, the system does not automatically switch to the
reference platform.
Example: You need to determine an unknown number of parts and the measurements should
be logged.
Confi guration: The “Counting" application is selected, and printout has been set up.
t Place empty container on the scale.
) t Tare the scale.
This is not required if the automatic tare function is active. The tare weight is
saved automatically when you place the container on the platform.
t Place a number of parts in the container for the reference quantity (in this
example, 20 pcs).
2 0 t Enter the number of parts using the keypad.
r t Start the calculation of the reference piece weight.
r t Set the number of reference parts using r: 1, 2, 5, 10, 20, etc.
O t Start the calculation of the reference piece weight.
t Add a quantity of uncounted parts to the container.
Operating Instructions Combics Indicators 57
Operation
To Next Page
Loading...
