Sartorius CH1NE - Operating Menu Overview: Weighing in Percent; Weighing in Percent Parameters Details

appl
O CL
4. 3. Activate Control Line for “Set" as:
4. 3. 1 * “Set" output
4. 3. 2 Ready to operate
4. 7. Activation of Outputs
4. 7. 1 Off
4. 7. 2 Always active
4. 7. 3 * Active at stability
4. 8. Number of Classes
4. 8. 1 * 3 classes
4. 8. 2 5 classes
4. 9. Parameter Input
4. 9. 1 * Weight values
4. 9. 2 Percentage
4.10. Automatic Printing
4.10. 1 * Off
4.10. 2 On
9. 1. Factory Settings for All Application Programs
9. 1. 1 Yes
9. 1. 2 * No
L Weighing in Percent
3. 5. Minimum Load Automatic Taring and Automatic Printing
Numeric menu as for Weighing
3. 6. Minimum Load for Automatic Initialization
Numeric menu as for Counting
3. 7. Automatic Taring: 1st Weight Tared
3. 7. 1 * Off
3. 7. 2 On
3. 8. Start Application with Most Recent Application Data when Combics is Switched On
3. 8. 1 Automatic (on)
3. 8. 2 * Manual (off)
3. 9. Resolution for Calculation of Reference Value
3. 9. 1 * Display resolution
3. 9. 2 Display resolution + 1 decimal place
3. 9. 3 Display resolution + 2 decimal places
3. 9. 4 Internal resolution
3.10. Decimal Places for Display of Results
3.10. 1 * None
3.10. 2 1 decimal place
3.10. 3 2 decimal places
3.10. 4 3 decimal places
3.11. Storage Parameter
3.11. 1 * At stability
3.11. 2 At increased stability
3.13. Reference Weighing Instrument
3.13. 1 * Off
3.13. 2 To weighing instrument WP1
3.13. 3 To weighing instrument WP2
3.15. Display of Calculated Value
3.15. 1 * Residue
3.15. 2 Loss
3.25. Tare function
3.25. 1 * The tare value entered is added to the stored tare value
3.25. 2 Overwritable tare value
9. 1. Factory Settings for All Application Programs
9. 1. 1 Yes
9. 1. 2 * No
66
Configuration