16
Preparation
A circle displayed in the upper right-hand
corner indicates that the balance/scale
has been disconnected from power
(the power cable was unplugged or due
to power failure).
● Turn on the balance/scale: Press e
> All symbols on the display light up briefly.
> The balance/scale performs a display test.
● To change configurations: see the chapter
entitled “Configuring the Balance/Scale"
● To load factory-set default configurations:
see “Configuring the Balance/Scale"
(menu code 9 - -1)
$ To tare the balance/scale: Press t
When the balance/scale is switched on, the
b is displayed until you press a key.
If the b symbol is displayed during
operation, this indicates that the processor
is performing a function and cannot receive
further commands at the moment.
Additional Functions
● Turning off the balance/scale: Press e
A zero in the lower left-hand corner
indicates that the balance/scale has been
switched off and is in stand-by mode.
To Next Page
Loading...
