7
Setting up the
Balance/Scale
Balances/Scales with an Analytical Draft
Shield Chamber:
!Move the sliding lock on the back of the
draft shield to the right (open position)
§ Position the draft carefully on the
balance/scale
§ Secure the draft shield in position by moving
the sliding lock device on the back of the
balance/scale to the left while pressing down
gently on the floor of the draft shield
§ Place the components listed below inside the
chamber in the order given:
– Base plate
– Shield disk
– Weighing pan
– Gem tray (GC models only)
To Next Page
Loading...
Need help?
General
