Connecting Electronic Peripheral Devices
§ Make sure to unplug the balance/scale from AC
power before you connect or disconnect a peripheral
device (printer or computer) to or from the interface
port.
Warmup Time
To ensure accurate results, the balance/scale must
warm up for 30 minutes before operation. Only after
this time will the instrument have reached the
required operating temperature.
Using Verified Balances/Scales in Legal Metrology
in the EU*:
$ Make sure to allow the equipment to warm up for at
least 24 hours after initial connection to AC power
or after a relatively long power outage.
* Including the Signatories of the Agreement on the
European Economic Area
9
To Next Page
Loading...
Need help?
General